At 12:13 PM 6/9/2005 -0500, you wrote:
> > You could make a simple test jig to check the orientation
> >(with gravity). Of course you're going to need to be carefull
> > not to solder the legs of, but it should't be do-able. If you've
> >got a solder oven it should be a piece of cake.
>
>Since the end result is essentially a test jig, that's what I'll
>do.  I marvel that this information is not bluntly and obviously
>presented in the datasheet.
>
>Mike H.

The ADXL311 is in phase-out status according to AD. The
suggested replacement (ADXL320) has the information on the data
sheet (page 10). Maybe it's the same..

The ADXL320 is a lot less bulky than the ADXL311 (< half the volume). ;-)

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com
->> Inexpensive test equipment & parts http://search.ebay.com/_W0QQsassZspeff


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist