On Tuesday 31 May 2005 10:52 am, microsoftwarecontrol scribbled:
> have a look what I find, from garage:
> a bottle heater, 300W and 50 to 110C temperature setting.
> full plastic and heating surface is taflon
>
> http://www.webjb.org/pub/img/05133/000_0964.JPG
> ...

I guess "perfect" is different for everyone.  My idea of perfect would be a 
clear container which has a width and height as big as I would need to make 
boards, but only 1" thick.  This way the board stays vertical.  Then increase 
the width a bit to hold an aquarium heater and an aquarium air pump.  Simple, 
low-cost and gets the job done well.  Drill a hole in the corner of the board 
first and secure a nylon wire tie thru it so it can be pulled out easily.

Cheers,
-Neil.



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist