What? !!!!!!!


> On 5/19/05, Olin Lathrop <olin_piclist@embedinc.com> wrote:
>> Matthew Miller wrote:
>> > This sounds good. IMO, I think the prototype area should be about
>> > 3/4 to 1.5 the size of the board.
>> 
>> Sorry, but I don't follow this.  How can the prototype area be bigger
>> than the board it's on?
> 
>   
>   great topic! 
> 
>   Let say you are prototyping only with SMD parts, did you heard about
> like that?
>   So, the board have at least two "faces" and an infinite numbers of
> layers. As biggest the technological development in the developers
> country, as many the numbers of layers on the PCB, no matter if are
> necessary indeed or not. :)
>    One half of one face is the circuit itself and 1.5 is the
>    prototyping area.
> 
> For those which need a bigger prototype area, prototyping also on
> layers 2 to 15 will be available at request.
> 
> best regards,
> Vasile
> 
> 
> 
> 
> 
>> 
>> Given the number of prototype pads I've shown in the schematic, the
>> prototype area would be about 5 inches wide by 1.5 inches deep.  This
>> will dictate the board with, which will probably be 6 inches to allow
>> for rubber feet and mounting holes.  I'm planning on the prototype
>> area being at the front of the board with the fixed circuitry in as
>> thin a strip as it will fit in at the back of the board.
>> 
>> 
>> *****************************************************************
>> Embed Inc, embedded system specialists in Littleton Massachusetts
>> (978) 742-9014, http://www.embedinc.com
>> --
>> http://www.piclist.com PIC/SX FAQ & list archive
>> View/change your membership options at
>> http://mailman.mit.edu/mailman/listinfo/piclist
>>
> 
> -- 
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist