I don't see a checkbox anywhere, I checked by reading it, and only saw my own code, does that say the debug code isn't programmed? How do I let the debug code be programmed? Paul James E. wrote: > Probably a moot point, but have you set the check box to have the debug > code load into the part when you program it? Just a thought. > > Regards, > > Jim > > > > > >>Dave Turner wrote: >> >> >> >>>Have you setup OSCCON? Check it out in the datasheet. Make sure your >>>OSCCON settings match your oscillator settings. >>> >>>On 5/23/05, Paul van der Linden wrote: >>> >>> >>> >>> >>>>Dave Turner wrote: >>>> >>>> >>>> >>>> >>>> >>>>>Yeh, I think if the software can't connect to the debug executive >>>>>(Which I think is because of your USB clock), it pauses the chip, or >>>>>puts it back into reset. I recomend trying setting the config bit >>>>>for oscillator to internal. Also, to change the speed, you can use >>>>>the OSCCON register. If this works, you know that the ICD2 not >>>>>supporting usb oscillator is the problem. >>>>> >>>>>On 5/23/05, Paul van der Linden wrote: >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>>>Michael Rathbun wrote: >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>>>On Mon, 23 May 2005 19:29:30 +0200, Paul van der Linden >>>>>>> wrote: >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>>>I think I've found the problem, but not the solution: >>>>>>>>When I program it with the icd2(without debug executive), it only >>>>>>>>runs if I disconnect the icd2. >>>>>>>>I've found out that if the icd2 is connected, mclr is always low. >>>>>>>>I think there is a fault in my circuit, but I can't find it. >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>This sounds like normal behaviour. If you want the loaded program >>>>>>>to run after the download with the ICD still connected, you need to >>>>>>>click the "release from reset" button in the IDE. >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>ok, that works, >>>>>>but I can't get an high on mclr in debug mode of the icd2 >>>>>> >>>>>>-- >>>>>>http://www.piclist.com PIC/SX FAQ & list archive >>>>>>View/change your membership options at >>>>>>http://mailman.mit.edu/mailman/listinfo/piclist >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>> >>>>> >>>>> >>>>> >>>>That doesn't work too. >>>> >>>>-- >>>>http://www.piclist.com PIC/SX FAQ & list archive >>>>View/change your membership options at >>>>http://mailman.mit.edu/mailman/listinfo/piclist >>>> >>>> >>>> >>>> >>>> >>> >>> >>> >>> >>Yes I did set OSCCON. >>I don't understand it, normal program and running works, but debugging >>isn't working. >> >>-- >>http://www.piclist.com PIC/SX FAQ & list archive >>View/change your membership options at >>http://mailman.mit.edu/mailman/listinfo/piclist >> >> > > > > -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist