Probably a moot point, but have you set the check box to have the debug code load into the part when you program it? Just a thought. Regards, Jim > Dave Turner wrote: > >>Have you setup OSCCON? Check it out in the datasheet. Make sure your >>OSCCON settings match your oscillator settings. >> >>On 5/23/05, Paul van der Linden wrote: >> >> >>>Dave Turner wrote: >>> >>> >>> >>>>Yeh, I think if the software can't connect to the debug executive >>>>(Which I think is because of your USB clock), it pauses the chip, or >>>>puts it back into reset. I recomend trying setting the config bit >>>>for oscillator to internal. Also, to change the speed, you can use >>>>the OSCCON register. If this works, you know that the ICD2 not >>>>supporting usb oscillator is the problem. >>>> >>>>On 5/23/05, Paul van der Linden wrote: >>>> >>>> >>>> >>>> >>>>>Michael Rathbun wrote: >>>>> >>>>> >>>>> >>>>> >>>>> >>>>>>On Mon, 23 May 2005 19:29:30 +0200, Paul van der Linden >>>>>> wrote: >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>>>I think I've found the problem, but not the solution: >>>>>>>When I program it with the icd2(without debug executive), it only >>>>>>>runs if I disconnect the icd2. >>>>>>>I've found out that if the icd2 is connected, mclr is always low. >>>>>>>I think there is a fault in my circuit, but I can't find it. >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>This sounds like normal behaviour. If you want the loaded program >>>>>>to run after the download with the ICD still connected, you need to >>>>>>click the "release from reset" button in the IDE. >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>ok, that works, >>>>>but I can't get an high on mclr in debug mode of the icd2 >>>>> >>>>>-- >>>>>http://www.piclist.com PIC/SX FAQ & list archive >>>>>View/change your membership options at >>>>>http://mailman.mit.edu/mailman/listinfo/piclist >>>>> >>>>> >>>>> >>>>> >>>>> >>>> >>>> >>>> >>>> >>>That doesn't work too. >>> >>>-- >>>http://www.piclist.com PIC/SX FAQ & list archive >>>View/change your membership options at >>>http://mailman.mit.edu/mailman/listinfo/piclist >>> >>> >>> >> >> >> >> > Yes I did set OSCCON. > I don't understand it, normal program and running works, but debugging > isn't working. > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist