Dave Turner wrote: >Have you setup OSCCON? Check it out in the datasheet. Make sure your >OSCCON settings match your oscillator settings. > >On 5/23/05, Paul van der Linden wrote: > > >>Dave Turner wrote: >> >> >> >>>Yeh, I think if the software can't connect to the debug executive >>>(Which I think is because of your USB clock), it pauses the chip, or >>>puts it back into reset. I recomend trying setting the config bit for >>>oscillator to internal. Also, to change the speed, you can use the >>>OSCCON register. If this works, you know that the ICD2 not supporting >>>usb oscillator is the problem. >>> >>>On 5/23/05, Paul van der Linden wrote: >>> >>> >>> >>> >>>>Michael Rathbun wrote: >>>> >>>> >>>> >>>> >>>> >>>>>On Mon, 23 May 2005 19:29:30 +0200, Paul van der Linden >>>>> wrote: >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>>>I think I've found the problem, but not the solution: >>>>>>When I program it with the icd2(without debug executive), it only runs >>>>>>if I disconnect the icd2. >>>>>>I've found out that if the icd2 is connected, mclr is always low. I >>>>>>think there is a fault in my circuit, but I can't find it. >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> >>>>>This sounds like normal behaviour. If you want the loaded program to run >>>>>after the download with the ICD still connected, you need to click the >>>>>"release from reset" button in the IDE. >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>> >>>>ok, that works, >>>>but I can't get an high on mclr in debug mode of the icd2 >>>> >>>>-- >>>>http://www.piclist.com PIC/SX FAQ & list archive >>>>View/change your membership options at >>>>http://mailman.mit.edu/mailman/listinfo/piclist >>>> >>>> >>>> >>>> >>>> >>> >>> >>> >>> >>That doesn't work too. >> >>-- >>http://www.piclist.com PIC/SX FAQ & list archive >>View/change your membership options at >>http://mailman.mit.edu/mailman/listinfo/piclist >> >> >> > > > > Yes I did set OSCCON. I don't understand it, normal program and running works, but debugging isn't working. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist