Speaking of ICD what's the different between CCS ICD and Microchip's ICD2. I called ccs tech support they said CCS icd is faster then microchip's icd2. Also do you use CCS IDE ? or it is better to use MPLAB and link it to ccs compiler ? Andre -----Original Message----- From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On Behalf Of Michael Rathbun Sent: Monday, May 23, 2005 11:02 AM To: Microcontroller discussion list - Public. Subject: Re: [PIC] ICD2 On Mon, 23 May 2005 19:29:30 +0200, Paul van der Linden wrote: >I think I've found the problem, but not the solution: >When I program it with the icd2(without debug executive), it only runs >if I disconnect the icd2. >I've found out that if the icd2 is connected, mclr is always low. I >think there is a fault in my circuit, but I can't find it. This sounds like normal behaviour. If you want the loaded program to run after the download with the ICD still connected, you need to click the "release from reset" button in the IDE. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist