Michael Rathbun wrote: >On Mon, 23 May 2005 19:29:30 +0200, Paul van der Linden > wrote: > > > >>I think I've found the problem, but not the solution: >>When I program it with the icd2(without debug executive), it only runs >>if I disconnect the icd2. >>I've found out that if the icd2 is connected, mclr is always low. I >>think there is a fault in my circuit, but I can't find it. >> >> > >This sounds like normal behaviour. If you want the loaded program to run >after the download with the ICD still connected, you need to click the >"release from reset" button in the IDE. > > > ok, that works, but I can't get an high on mclr in debug mode of the icd2 -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist