Howard Winter wrote:

>Paul,
>
>On Mon, 23 May 2005 10:01:07 +0200, Paul van der Linden wrote:
>
>  
>
>>Hi,
>>I'm just starting with pic-microcontrollers, and have ordered the icd2 
>>from microchip.
>>But it isn't working, I always get this error after programming the 
>>device ( I have selected the icd2 as debugger):
>>ICD0083: Target not in debug mode, unable to perform operation
>>Can anyone help me, what do I wrong?
>>    
>>
>
>Yes, the ICD2 can act in two modes, as a Programmer or as a Debugger - the latter needs a PIC that supports 
>debug mode, and it looks like you're just trying to program it.
>
>The correct procedure to start up is from the top menu to select "Configure" then "Select Device" and choose 
>the PIC you're using, then "Programmer" then "Select Programmer" from the top menu, then "MPLAB ICD2" and 
>you'll be set up properly to use it as a programmer.  Don't touch "Debugger" unless you want to use it that 
>way and know how to do so!  :-)
>
>Cheers,
>
>4
>Howard Winter
>St.Albans, England
>
>
>  
>
I was testing if it is running if I selected the icd2 as programmer, and 
then apply power.
It looks like it's not running.
If I understand it good this will light a led on the RB0 port:

        LIST P=18F4550, R=DEC

        #include "P18F4550.INC"

        CLRF  TRISB
        BSF     PORTB, 0
        END

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist