isn't alalog only for input?  If it's set to output, how can it be analog?

On 5/21/05, Andre Abelian <andre@ditechnology.com> wrote:
> Dave,
> 
> You need to make RA3 digital I/O the default is set to analog
> 
> Andre Abelian
> 
> 
> 
> 
> 
> 
> -----Original Message-----
> Subject: [PIC] Very strange RA3 pin
> 
> Hey
> 
> I have got a very strange RA3 pin.  It is being used as an output,
> with an LED connected.  I am using a PIC18F1320.  For some reason, the
> LED on RA3 always stays off, but, and this is the strange part, when I
> press the active low switch on RB0, the LED works normally.  I have
> checked nothing in my code is referencing porta,3, and the hardware is
> fine.  BTW, I'm using the PICDem 4 board, and a MPLAB ICD2 as a
> programmer.
> 
> --
> 
> All us base are belong to you.
> 
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
> 
> 
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
> 


-- 
--

All us base are belong to you.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist