With most programmers you can program just the eeprom or just the program memory If this is possible with your programmer you could save a hex image of the eeprom and a separate image of the program Smarter programmers also dont program ff bytes in eeprom so the complete image of the eeprom which in itself is pretty small to begin with should not take much time. Peter ----- Original Message ----- From: "Jan-Erik Soderholm" To: Sent: Friday, May 20, 2005 4:20 PM Subject: RE: [PIC:] Pre-loading the EEPROM using mikroPascal ? > peter@whacky-scientist.com wrote : > >> OK , didnt check out the program before but there is a >> workaround >> >> Build your program >> Press F11 (picflash programmer tool) >> click eeprom (bottom right hand) >> edit eeprom memory >> click save hex >> done >> >> Peter > > OK, Thanks. That seems to "work". But with a few drawbacks. > The above steps has to be re-done at each build. > The eeprom editor in pickflash only uses hex format. > When saving the HEX file, all eeprom is included even those > parts that are left un-programmed. > > I'll see if the support know anything about it... > > Jan-Erik. > > > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > > -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist