> I've saved this email to look into this later.  I need to 
> look at your bus
> spec (electrical and mechanical) before deciding how to 
> address this, and I
> can't do that right now.

bus spec is simple: gnd, 5V, (up to) 8 PIC I/O pins. Connector is a 10
pin 'shrouded header'. My supplier calls it an ML10. It is about the
cheapest connector I could find. gnd and 5V are swapped as to what you
would expect because some dark-side demo boards do this too.

Wouter van Ooijen

-- -------------------------------------------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products
docent Hogeschool van Utrecht: www.voti.nl/hvu
 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist