Matthew Miller wrote:
> This sounds good. IMO, I think the prototype area should be about 3/4
> to 1.5 the size of the board.

Sorry, but I don't follow this.  How can the prototype area be bigger than
the board it's on?

Given the number of prototype pads I've shown in the schematic, the
prototype area would be about 5 inches wide by 1.5 inches deep.  This will
dictate the board with, which will probably be 6 inches to allow for rubber
feet and mounting holes.  I'm planning on the prototype area being at the
front of the board with the fixed circuitry in as thin a strip as it will
fit in at the back of the board.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist