Augusto,

What you need to do is to run your board through one of the cam processors.=
=20
In the control panel, you will see a section for Cam Processors (or=20
something similar, I don't have eagle on this computer). Look in there and=
=20
I'm sure you need the one that says Gerber274 (or something similar). To=20
generate the drill files, there should be an Excellon.cam. These are the=20
ones I use to run our milling maching at school, it might be different for=
=20
the factory you are dealing with.=20

There are also lots of tutorials online to help you along the way.

-Tarun.

On 5/18/05, Augusto Yipmantin <augustoy@centaurocomunicaciones.com> wrote:
>=20
>=20
> Hi all,
>=20
> I am using Eagle 4.03 to design pcbs. Factory request me gerber data
> because the .sch and .brd files are not enough. May anyone be able to
> tell me how to generate the gerber data files?
>=20
> Regards,
>=20
> Augusto
>=20
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>=20



--=20
Tarun Grover
Computer Engineering & Management V
McMaster University, Hamilton, ON, Canada
Vice-Chair, McMaster IEEE Student Branch
grovert@mcmaster.ca - tarun.grover@gmail.com
tarun_grover@ieee.org - deathstorm@rediffmail.com
905-518-2743
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist