Peter wrote:
> If he had intended to then he would have clicked Tools->ERC before
> generating the board and found out that it's unconnected.

That's not going to find an unconnected output unless that output is the
only thing driving the net with all the rest of the connections inputs.
However, that wasn't the case since the remaining connections were to
passive components if I remember right.

Also remember that this guy posted a schematic and specifically asked for
comments.  I pointed out the missing connection as one of several problems I
noticed.  If this had been a real schematic (and we didn't know it wasn't at
the time), this could well have turned into an incorrect board eventually.
It also pointed out a bad use, or at least a misconception of how to use
Eagle.  Again, he asked.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist