I'm feeling a little bad for the likely overwhelmed O.P. right now, sure 
he didn't expect this design-by-committee bit.
But while we are at it: SIP connectors for all unuse pins (for when "we" 
upgrade to the LCD version).  :o)
D

Roland wrote:
> Looks good!
> 
> I know one can go to town on what to put on the board, but a second LED on one of the port lines(on pcb) is invaluable. It allows easy checking on power up/diagnostic//// without having to actually make connections to the board.
> 
> Also, I see some port lines don't come out, like TX does but not RX or RB0.
> Maybe RA5 could be that diag. LED
> 
> Also;
> - I see there is no provision for the little capacitors across the Xtal.
> - The pads that are directly into the copper ground plane will be quite difficult to solder unless broken into islands.
> - Since one is unlikely to use a top-silk, some text on the copper can be really helpful too. Also for the PCB house to identify your board (remember to flip text!)
> Some text worth considering;
> - pcb name
> - date or serial No.
> - +  -
> - 1..6
> 
> 
> Regards
> Roland

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist