At 17.11 2005.05.02 +0200, you wrote:
>Dave Turner wrote :
>
>> I have set the osc to INTRC-CLKOUT, which should be about 8MHz, but
>> with the MPLAB SIM, I have to set the processor speed to about 20Khz
>> to get near to the speed I'm using.  Am I setting up the clock
>> incorrectly?  All I changed was the __CONFIG.  Is there another place
>> to change the clock speed?
>
>And you don't think that the fact that "about 20Khz" happens to be quite
>close to 31.25 Khz would ring a bell ??
>
>As I wrote in another post :
>
>--  Have you setup OSCCON correctly ?
>--  I think that 31.25 Khz is the POR (power on) default.
>
>Try to set SIM to (something closer to) 31.25 and see if you
>don't get the same time as you see in your hardware.
>
>Then setup OSCCON correctly to get 8Mhz.
>
>And yes, this actualy means that the PIC will be running
>slowly *until* you set OSCCON in the code. By changing
>OSCON you can "gear" the PIC up and down in 8 steps
>between 8 Mhz and 31.25 Khz as you like.

Cool, now if they only added a Reverse Idler bit in OSCCON.. :D

(Reverse Idler =3D Backaxel p=E5 Svenska)


>
>Jan-Erik.
>
>=20

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist