Mark Scoville wrote:

> I click on the "Release from reset" button and my application begins
> running. All is well. About 10 minutes later I notice my application
> freezes, and if I measure MCLR with my DVM it reads 1.7Vdc - If I click
> on "Hold in reset" button MCLR goes to 0Vdc. If I then click on "Release
> from reset" MCLR goes to 5Vdc and application starts running. But, 10
> minutes later (or so) MCLR is again at 1.7V and the application has
> stopped.

> Maybe the ICD2 I have is a dud. Any ideas folks?

Maybe... The only input I can provide is that mine doesn't do this. I
routinely have it connected to the circuit for long times while the
application is running, after using it as a programmer. I can confirm that
it stops the application through power cycles -- not sure whether that
happens when it goes to sleep or when it wakes up, though, or whether
that's a clean reset or 1.7 V. Haven't checked on that yet, as neither me
nor my computer tend to go to sleep while working :)

Gerhard
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist