Hi All,

I am trying to get the Microchip USB Bootloader to go using my own 
hardware, I have set up a board with a 20MHz xtal and connected up the 
the USB socket, adjusted the config bits to enable the USB reg and all 
looks promising, I plug it into the PC and it comes up with new hardware 
found but when ever I point it at the drive in "C:\MCHPFSUSB\Pc\MCHPUSB 
Driver" the system decides to use the default driver from Microsoft and 
fails to load, I thought it may be a problem with the PC so I tried a 
fresh system and It does exactly the same, I am trying to use the MC FS 
Demo tool with this board and I have connected up a switch to put it 
into the correct mode, Am I doing the right thing trying to load this 
driver?
Any suggestions?

regards


Lee McLaren
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist