>I will be very pleased if anyone can tell me how to AUTO PLACE
> components in a Eagle V. 4.03 board.
>
> Regards,
>
> Augusto
>
Go to www.cadsoftusa.com and browse around until you find the downloads 
section and the collection of ULPs.  There are a couple of different 
auto-place ULPs.  I've tried them and I wasn't all the impressed.  I place 
all my boards manually.  Then I route critical traces manually.  If the 
board is small (2 layers and less then 50 parts typically) I just route all 
by hand otherwise I let the autorouter have a crack at it.  But then I need 
to go back through and clean up some of its nonsense.

There are a few autorouter packages out there that can deal with Eagle 
boards.  Check out the Eagle/Cadsoft newsgroups.  Again I reference you to 
www.cadsoftusa.com for more information on the newsgroups.

Rob Young
rwyoung@ieee.org
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist