Hi,
 I am trying to build a simple one way serial radio link
between two pic circuits. I do not seem to be getting a
signal and I am not sure how to test the radio xmit and rcv
boards. I have a function generator and a tds 210 60 Mhz
scope. I tried putting a 500 hz square wave in the xmitter
and scoping the linear output pin but no joy.
I originally tried putting character data thru the xmitter
at 300 bps. Anything I received came out as garbage. I am
not sure if it was picking up garbage or if the data was
being mangled. My data packet was 5 AAh followed by 5 letter
"F". I don't think it is the code because it comes out on
hyperterminal fine. Also I am sending the data using a
software uart with inverted serial data.
The xmit and receiver modules are here
>>http://blitzlogic.8m.com/rf.htm

Any help or suggestions would be appreciated.

Thanks,
	Kevin (The software guy :))



_______________________________________________
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist