I can't get this simple program to program or work.

Configuration:
PIC16F88-I/P on an Olimex PG4-D board, 20 MHz crystal    (http://olimex.com/dev)
Serial port cable from IBM Thinkpad T30 (on a dock/port replicator)
running Windows 2000.
ICPROG 1.05C,  configured for Windows API (as per directions for
Windows NT --> 2000) and for 16F84A (there was no 16F88 line).
MPLAB 6.60

Config lines in the .asm file:
               __CONFIG _CONFIG1, _CP_OFF & _CCP1_RB3 & _DEBUG_OFF &
_CPD_OFF & _LVP_OFF & _BODEN_ON & _MCLR_OFF & _PWRTE_ON & _WDT_OFF &
_HS_OSC
               __CONFIG _CONFIG2, _IESO_OFF & _FCMEN_OFF

Firstly, a number of constants don't seem to be defined
(_WRT_ENABLE_OFF is not defined, so I removed it from the _config
line) in the include file.
When I used ICPROG to write it, it failed on the readback/compare.

Anybody have a reasonable config value or list for this MCU?
Anybody have a working program and/or MPLAB project to blink the LED
(connected to RA2 on the Olimex PG4-D board) for the 16F88-I/P?
Set of sample programs for the 16F88?   16F877A (which I'm going to
stick on an Olimex P40-B)?

Thanks.
-Ralph
_______________________________________________
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist