I get that error if I have code protect set on any flash or if I have
table write disabled on any flash or the config bits (I'm used to working
with the PIC18F series).

Good luck!

Harold


> I'm stumped. I've never had this error before unless the clock was
> broken (it isn't).
>
> The PIC (PIC16LF88) runs perfectly at 3.5V, will program my
> "wink" test fragment from the ICD2 as a programmer, and when
> selected as debugger, all seems OK except for the error. (NO, I
> don't have ICD2 selected at both programmer and debugger).
>
> Neither PGC, MCLR, or PGD is connected to anything except the
> debugger. Well, MCLR has a 47K pullup on it only to VDD.
>
> I haven't tried to run the PIC at 5V because it has some 3.6V max
> peripherals attached.
>
> The PIC runs flawlessly for the wink test.
>
> Any ideas, fellow PIClisters?
>
> --Bob
>
> --
> Note: Attachments must be sent to
> attach@engineer.cotse.net, and
> MAY delay replies to this message.
>        520-219-2363
>
>
>
>
> --
> Note: Attachments must be sent to
>  attach@engineer.cotse.net, and
>  MAY delay replies to this message.
>         520-219-2363
>
> _______________________________________________
> http://www.piclist.com
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>


-- 
FCC Rules Online at http://www.hallikainen.com
_______________________________________________
http://www.piclist.com
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist