I only have 1 pin and that will be 19200 232 bitbang (output only). Al ----- Original Message ----- From: "Jan-Erik Soderholm" To: Sent: Saturday, September 18, 2004 6:27 PM Subject: RE: [PIC]Serial LCD Display > redtock8@dxtron wrote : > >> Also I forgot it has to be bit banged. > > OK then. > Are you plannning to use RS232 or SPI ? > >>From the data sheet ("Appendix A: Interface Options") : > > ""Low-Speed SPI" is intended to be used with low-end > embedded microprocessors that lack a hardware UART." > > I think that SPI is easier to bit-bang then async serial, not ? > You could probably just get any SPI bitbanger and use that. > Just don't run to fast, as the data sheet warns about. > > Jan-Erik. > _______________________________________________ > http://www.piclist.com > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist _______________________________________________ http://www.piclist.com View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist