Howard,

The pins themselves are rectangular and measure 0.81mm at the widest point.
(Although the spec sheet says 0.76mm)
They fit into the holes standard on the prototype strip board I use fine
however these holes are 1.1mm, I guess you'd have to do a layout with 1mm
rather than 0.8mm holes.

Kev/.


----- Original Message -----
From: "Howard Winter" <HDRW@H2ORG.DEMON.CO.UK>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Monday, August 23, 2004 2:20 PM
Subject: Re: [PIC:] Olin's Easyprog - ZIF connectors


> Kev,
>
> On Mon, 23 Aug 2004 11:31:19 +0100, Kev Pearce
> (kevp.com) wrote:
>
> > I have one of the Maplin 40 pin ZIF/Universal Test
> Sockets in front of me.
> > It is marked ELK040.
>
> For future reference, does it look as if it will fit
> into normal holes in a PCB (intended for ordinary IC
> sockets) of has it got the wide pins that the 3Ms have?
>
> Cheers,
>
>
> Howard Winter
> St.Albans, England
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
>

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu