Sean A. Walberg wrote:

> I've put together a Wisp628 which I can connect to, but it's unable to
> read the ID off the target chip. When I measure MCLR, it's at 8v
> instead of the expected 13V.

Is the pull-up resistor of /MCLR on the target board at least 33K, as
the Wisp628 doc recommends?

Regards, Rob.


--
Rob Hamerling, Vianen, NL phone +31-347-322822
homepage: http://www.robh.nl/

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics