Hi,

I've put together a Wisp628 which I can connect to, but it's unable to
read the ID off the target chip.  When I measure MCLR, it's at 8v
instead of the expected 13V.

I've switched out all the parts in the charge pump, and even gone so far
as building a new board, but I get the same thing.

The voltages on C6/7/8's positive terminals are 8, 9.5, and 9V
respectively while the pump is active.  While I see about 3V on pin 9 of
the PIC, I don't see anything on 6 or 5.  Since I don't have a scope, I
don't know if those last numbers are meaningful, though.

I'm not sure where to go from here...  I don't have any extra
16F628-20's to try, unless a 16F648 can be used in its place.

Thanks,

Sean

--
Sean A. Walberg <sean@ertw.com>                 http://www.ertw.com

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads