> I'm getting geared (hah!) up to offer a small (6"x6" travel) CNC mill with a
> "brains on board" three axis controller and custom software that accepts
> gerbers or HPGL. The only requirement is for an old Windows BOX (e.g. P1)
> and a power supply.

This sounds *very* interesting. If you can sell the setup for $500 I
would be interesting in buying one *if* it could do more than PCBs.

> I'm not sure anyone will be willing to do that at this point... But I really
> don't want to go forward before I get that feedback and I can't afford (at
> this point) to underwrite that effort. If no one comes forward, I'll have to
> save my pennies until I can go it alone.

Unfortunately I don't have the money at this time. I hope to have it when
you can sell them.
--
D. Jay Newman           ! DCX - it takes off and lands base down,
jay@sprucegrove.com     !       as God and Robert Heinlein intended.
http://enerd.ws/robots/ !

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu