It depends on the address of 'register1'.

If register 1 is in the access bank (ie: 0..7F or F80..FFF) then the
assembler automatically uses access bank mode.

Otherwise, the assembler assumes you have been smart enough to set up the
bank register properly, and it uses regular mode.



FYI: I often use the following scheme for allocating memory on 18F
applications:

I set BSR to 1 and leave it there.

Now I can access data in the access bank, as well as bank 1 with normal
instructions without having to play with banking at all.

I use the remaining banks to store buffers and other large data structures
that I access via the FSRs or sometimes MOVFF instructions (which don't care
about banks).

Bob Ammerman
RAm Systems

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu