----- From: "Mark E. Skeels" <meskeels@e

> You didn't say it had to be in the 450MHz range, so if it's a one off, you
> might look at TI's TRF6901 demo boards.

Actually I said  "across the spectrum of  ~100 to 500 MHz"  this means
microprocessor controllable across the range of ~100 to 500MHz. Thank you
for trying but 900MHz 16 channel is nowhere close to what I specified.

> http://focus.ti.com/docs/toolsw/folders/print/msp-trf6901-demo.html
>
> They run in the 900 MHz range, and you can select from 16 frequencies.
>
> It comes with an on-board MSP430 flash uP and source code for a simple
game.
>
> I think it's $100.00 for two modules, with onboard copper antennas.
>
> The pcb has some options and some leds and switches, as well as layout for
> RS-232 connections.
>
> It works well out of the box.
>
> Mark
>
>
>
> ----- Original Message -----
> From: "Falcon Wireless Tech Support - KF4HAZ"
> <techsupport@f
> Subject: [EE]: Very low power transmitter
>
>
> > I have a side project, probably just a one off, where I need a low power
> > transmitter.
> > Something around the range 2.5 to 25mw across the spectrum of  ~100 to
500
> > MHz (does not have to have a flat output power level across the entire
> > spectrum)
> > Needs to be capable of  about 1.25 to 2.5 KHz deviation (sine wave or
> > something close, squareish waves would be a plus) in the low  audio
range.
> > Transmit frequency needs to be controllable via a micro-controller
(again
> > accuracy not terribly critical but this is the one area that should be
> > fairly accurate) if I tell it to transmit at 450MHz it should be within
5
> or
> > 10KHz of this frequency and reasonably stable.
> >
> > KF4HAZ - Lonnie

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu