Hi Jim
 sorry about the delay on answering, but this is my email at work and I just
went home on Saturday before your answer.

I am using the schematic editor and I used the GND/CAPSYM symbol from the
place ground menu (orcad 10.0)

best regards

Luis

-----Original Message-----
From: Jim Tellier [mailto:jimtellier@COX.NET]
Sent: 03 July 2004 17:53
To: PICLIST@mitvma.mit.edu
Subject: Re: [EE:] PSPICE


Luis Moreira wrote:
> I am learning how to use ORCAD PSPICE and I have done an inverting amp
> circuit with an opamp as normal. Apart from the usual
> resistors for gain I fitted a resistor from non inverting input to ground.
I
> am getting an error on that node it keeps on telling me that there are
less
> than two connections on that node! the resistor is connected on one side
to
> ground and the other to the opamp so there are two connections... is it
the
> ground connection ? Can someone help.

Luis,
   Are you doing this with the Schematic editor, or is it a hand-generated
netlist?
Can you post it here?  I'm curious what symbol or node you're calling
"ground", for
one thing.

Jim

> --
> http://www.piclist.com#nomail Going offline? Don't AutoReply us!
> email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads