I am trying to make a project that uses some bit patterns that I would like to
store in the EEPROM (it's a learning project for me)

I found on the site informations that I should use 'org 0x2100' and then 'de'
commands to get the data into my hex file, however my tait style programmer
is refusing to program it. The program (occasionally) loads properly, but when
the verify happens, it will fail at address 0x2100, reading back 0x81 instead of
0x3f.

I am going to replace this programmer with a Wisp628 once my samples come in and
I can easily wait until then if the wisp will do the job, does anyone have any
experience with it?

Anthony

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body