I did not think about that but of course that is a possibility. Don't
know who to manage without you all guys on the list. You are the best!!!

Regards
/Ake

-----Ursprungligt meddelande-----
Fran: pic microcontroller discussion list
[mailto:PICLIST@MITVMA.MIT.EDU]For William Chops Westfield
Skickat: den 18 juni 2004 11:56
Till: PICLIST@MITVMA.MIT.EDU
Amne: Re: SV: SV: Material to fill a box


On Friday, Jun 18, 2004, at 00:55 US/Pacific, Ake Hedman wrote:

>> I have looked around for electronic filling
>> material and obviously found the epoxy type. But it's so damn
>> expensive. Is there some lower cost material one can use?
>>
note that general purpose epoxy or polyurethane resins are considerably
cheaper in moderate quantities, and can be "filled" with a large
percentage of "really cheap" stuff like sawdust or sand...

BillW

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body