These are the RAM chips that I salvaged from an old
video card:

http://www.jameco.com/Jameco/Products/ProdDS/93374.pdf

I was thinking I could put 2 chips' address inputs on
the high byte of the IDE data bus, and then put each
of their 4 IO pins on the low/high 4 bits of the low
byte of the IDE databus.  This way I believe I could
write two chips simultaneously (so 8bits at a time)
and each chip would use the same memory addresses.  I
think this would be pretty easy for reading/writing to
the RAM.

What do you think?


=====
MJ Brush
LeftClick.ca Internet Media Services
mbrush@[NOSPAM]leftclick.ca

______________________________________________________________________
Post your free ad now! http://personals.yahoo.ca

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads