I've got a PIC18F458, and an ISP-Pro programmer and a 2840 Development
Board(also from http://www.basicmicro.com). Has anyone worked with this
and gotten it to work properly? (I've asked at the forum on thier site,
but gotten no answer so far, figured I'd try here too).

When I attempt to program it tells me that the assembler file is fine
and without errors, and then says "Programming...", yet nothing
happenes. When I try to read from it, I get an error saying that the
Device ID is incorrect. (Im able to read anyway, and the .hex file I end
up with is all 00 up untill 0x7FF and then all FF after that).

Anyone have any clue what is going on?
All and any help is appreciated,
Fredrik Huldtgren

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body