> On Wed, 14 Apr 2004 06:59:06 +0100, Matt Marsh wrote:
>
>>I guess that this is mainly due to the size that I exported the
>>image to when I created it as a .png file. If I print from within Eagle
>>itself, it comes out just fine, fitting nicely on one page. When
>>exporting to .png you have to specify what dpi you want to use to
>>control the size, I should have perhaps picked something a
>>little lower so sorry about that.
>
>
> One way to create a file for your schematic is to print to a file
> using a Postscript printer driver. You don't need to install a
> Postscript printer, just the driver.
>
> You can then use this website:
>
> http://www.ps2pdf.com
>
> to convert it into a PDF file.

You're right, a PDF would have been much better, and would have
been easy enough to do from Linux anyway. I did look to see if
Eagle supported exporting directly to PDF which would have been
nice, but yeah could have gone via postscript instead. I shall
do that next time.

Thanks,
Matt

--
Matt N. Marsh
Email: matt@mattmarsh.net          Yahoo: marshmn
  Web: http://www.mattmarsh.net/  Jabber: mattmarsh@jabber.org
                                     MSN: matt@mattmarsh.net
                                     ICQ: 250467363
                                     AIM: MattMarshUK

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body