Bob Barr wrote:

>On Wed, 14 Apr 2004 06:59:06 +0100, Matt Marsh wrote:
>
>
>
>>I guess that this is mainly due to the size that I exported the
>>image to when I created it as a .png file. If I print from within
>>Eagle itself, it comes out just fine, fitting nicely on one page.
>>When exporting to .png you have to specify what dpi you want to use
>>to control the size, I should have perhaps picked something a
>>little lower so sorry about that.
>>
>>
>
>
>One way to create a file for your schematic is to print to a file
>using a Postscript printer driver. You don't need to install a
>Postscript printer, just the driver.
>
>You can then use this website:
>
>http://www.ps2pdf.com
>
>to convert it into a PDF file.
>
>

The pdf995 driver http://www.pdf995.com/  is free as long as you don't
mind the nag screen. I bought the licence (~ $20 IIRC) to stop it though.
You just print straight to pdf - can't get any easier than that! :-)
David...

--
___________________________________________
David Duffy        Audio Visual Devices P/L
U8, 9-11 Trade St, Cleveland 4163 Australia
Ph: +61 7 38210362   Fax: +61 7 38210281
New Web: www.audiovisualdevices.com.au
___________________________________________

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body