On Wed, 14 Apr 2004 06:59:06 +0100, Matt Marsh wrote:

>I guess that this is mainly due to the size that I exported the
>image to when I created it as a .png file. If I print from within
>Eagle itself, it comes out just fine, fitting nicely on one page.
>When exporting to .png you have to specify what dpi you want to use
>to control the size, I should have perhaps picked something a
>little lower so sorry about that.


One way to create a file for your schematic is to print to a file
using a Postscript printer driver. You don't need to install a
Postscript printer, just the driver.

You can then use this website:

http://www.ps2pdf.com

to convert it into a PDF file.


Regards, Bob

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body