Wouter van Ooijen wrote :

> As far as I can see from the datasheet an 18LF
> is the same or better compared to an 18F. It this
> correct?
>
> Wouter van Ooijen

Hi.
The only paramater I've found that points a lower/worse spec
for th LF parts, is in table 17-1 on page 186 (DS39564B).
As I read it, you must run the LF parts at a lower speed if using
the ADC. Or did I miss-read the table ?

Jan-Erik.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.