I'm looking for experiences/recommendations any of you may have about
getting circuit boards stuffed.

I have a small board (about 1 inch dia round) that needs a 12F629 (SOIC)
and two 1206 resistors soldered down. It gets some other parts too, but I'm
pretty sure that'll have to be done by hand, and I'll have to do it
in-house (parts have to be held by a fixture while they're soldered). I
need 100 of them in the next month or two, and could need a couple thousand
by the end of the year. I just don't want to have to solder the surface
mount parts.

Suggestions on who would want to do this work? What might you expect it to
cost?

Thanks,
-Denny

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu