pic microcontroller discussion list wrote:
> Ok but it is necessary tu have some isolators( resistors i think ) on
> the target's pins do you know exactly what ?
>=20
> Mike Hord a =E9crit:
>=20
>> Sure, just make a header with the same pinout as the PIC and
>> run the leads out to your target board.
>>=20
>> Just make sure to keep the current consumption down and
>> probably don't connect the VCC on your target to the VCC
>> on the PICSTART+.  Keep the wires short, as short as possible.
>>=20

the isolation circuit depends on what else the pins are connected
to. Maybe some jumpers if it's a hobby project. you could use
the same thing for isolation Vdd.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body