Ok but it is necessary tu have some isolators( resistors i think ) on=20 the target's pins do you know exactly what ? Mike Hord a =E9crit: > Sure, just make a header with the same pinout as the PIC and > run the leads out to your target board. > > Just make sure to keep the current consumption down and > probably don't connect the VCC on your target to the VCC > on the PICSTART+. Keep the wires short, as short as possible. > > It has been done, but you're almost always better off just > getting an ICD2. > > Mike H. > >> From: jisak >> Reply-To: pic microcontroller discussion list >> To: PICLIST@MITVMA.MIT.EDU >> Subject: [pic]: ICSP >> Date: Mon, 15 Mar 2004 12:43:00 +0100 >> >> Hi all >> >> Do you know if it is possible to make ICSP with Picstart+ for 12fxxx, >> and how ? >> >> Thank you >> >> --=20 >> http://www.piclist.com#nomail Going offline? Don't AutoReply us! >> email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > > _________________________________________________________________ > Fast. Reliable. Get MSN 9 Dial-up - 3 months for the price of 1! > (Limited-time Offer)=20 > http://click.atdmt.com/AVE/go/onm00200361ave/direct/01/ > > --=20 > http://www.piclist.com#nomail Going offline? Don't AutoReply us! > email listserv@mitvma.mit.edu with SET PICList DIGEST in the body > > -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body