At 03:49 PM 2/28/2004 -0500, you wrote:
>I've made a handy dandy schematic for this available on my
>website: http://www.excelsus.com/~remy/DualStepperSchematic.pdf
>
>That schematic shows one half of the 4 steper circuit I am
>planning to build on one PCB.  When I do, I will separate power
>supplies, use a DIP 1k resistor array between the PIC and darlingtons, and
>put bypassing on the logic power/gnd leads.
>
>Thanks for all your assistance so far. :)

Gustaf:  Connect the zener to GND rather than 5V. Other than that, it
looks good. Why the LS244?

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.