Hi Alan
that's very strange...
When I used stepper motors in the past I just used them with rated voltage
and current and had no problems...
I am talking of unipolar motors.
regards
        Luis


-----Original Message-----
From: Alan B. Pearce [mailto:A.B.Pearce@RL.AC.UK]
Sent: 27 February 2004 17:16
To: PICLIST@mitvma.mit.edu
Subject: Re: ] Stepper motor voltage question


>I built a desktop milling machine a couple of years ago.  It used
>5v rated steppers, so I hooked them up to 5volts.  I got no torque
>out of them at all.

That would be correct.

>Called the guy I bought them from, and he said that, though rated
>for 5volts, steppers need at least 4 to 6 times the rated voltage
>to work properly.

The 5V rating is what you would use to supply enough current for them to
hold position. This limits the coil current to a value that limits heat
dissipation.

>I run my mill on 24volts.  Has plenty of torque, and have never
>had a problem with any of the motors.

That would be a typical voltage to get the current to increase at sufficient
rate while stepping. However if leaving a motor stopped for a while at this
voltage you will find the motor will get very hot, possibly damaging winding
insulation. The way I have seen this sorted is to use a switchmode regulator
chip with a "change voltage" control done by an external transistor changing
the sense divider ratio. When the control processor wants to move the motor
it switches to high voltage, waits a few milliseconds then starts stepping
the motor. A few milliseconds after finishing the motion the voltage is
switched back to the holding voltage.

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.