>-----Original Message-----
>From: spacecat [mailto:spacecat@450SE.CO.UK]
>
>Does anyone have any ideas how to get data into a pc at much
>higher than USB1 Speeds.?
>
>I was wondering if there was anything like the FTDI USB1 chip
>i.e. hardware
>+ drivers.
>
>I know you could do it with an FPGA but that would be to big a
>project for me.
>
>Something like a bridge chip for usb2,firewire or ideally A
>PCI bridge chip with a simple I/O and driver system..

You can buy PCI prototpye boards that have all the bus interface devices
already present and a development area on the PCB.  However, they are not
cheap!

http://www.quancom.de/qprod01/eng/pb/pci_prototype_card.htm

Regards

Mike




=======================================================================
This e-mail is intended for the person it is addressed to only. The
information contained in it may be confidential and/or protected by
law. If you are not the intended recipient of this message, you must
not make any use of this information, or copy or show it to any
person. Please contact us immediately to tell us that you have
received this e-mail, and return the original to us. Any use,
forwarding, printing or copying of this message is strictly prohibited.
No part of this message can be considered a request for goods or
services.
=======================================================================
Any questions about Bookham's E-Mail service should be directed to
postmaster@bookham.com.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu