>From: Edward Cooper > >Cheers everyone for your help, some invaluable advice there! > >Colin- Will this change the holes that are already there? If not is >there a way I can get Eagle to just round up the drill sizes to the >nearest one in that selection? There might be a ULP that does this, but I'm not so sure it's a good idea. There's bound to be some judgment calls. Note that there's no 0.8 mm drill, so 0.031 in. holes for a 5 mm LED, for example, would round down to 0.7 mm, which would be too small. Now, 0.032 in. holes woiuld round up to 0.9 mm which would be OK, except that, if the pad diameter is fixed, you could end up with an annular ring that is too narrow; and if the pad width is set to auto you could end up with a pad that is too wide. Best to just get in there and set the hole and diameter to what you want; you can group the pads, after all . Some folks have suggested letting the board house worry about it but I'm not at all comfortable with that. Colin _________________________________________________________________ Add photos to your messages with MSN 8. Get 2 months FREE*. http://join.msn.com/?page=dept/features&pgmarket=en-ca&RU=http%3a%2f%2fjoin.msn.com%2f%3fpage%3dmisc%2fspecialoffers%26pgmarket%3den-ca -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body