> An important point not to be missed is the outcome for the original
> questioner. If a significant number of people usefully assist him in
> increasing his capabilities then he will be well served.

Well said.

This is from pp.239-249 of the datasheet.
http://www.microchip.com/download/lit/pline/picmicro/families/18fxx20/39609b.pdf

>And this is the configuration:
>Config1  = 2500
Main oscillator is source
FOSC2 and FOSC0 set => EC oscillator w/ OSC2 as RA6

>Config2  = 000F
Brownout reset enabled, powerup timer disabled

>Config3  = 0080
WAIT set, Extended Microcontroller mode
CCP2 I/O multiplexed with RE7

>Config4  = 0081
Debugger disabled.  RB6:7 are GPIO
Low voltage ICSP disabled
Stack full/underflow causes reset

>Config5  = C0FF
Data EEPROM not code-protected
Boot block not code protected
Blocks 0-7 not code protected

>Config6  = E0FF
Blocks 0-7 not write protected
Data EEPROM not write protected
Boot block not write protected
Config registers not write protected

>Config7  = 40FF
Blocks 0-7 not protected from table reads executed in other blocks
Boot block not protected from tabler reads executed in other blocks

>ID Value = 0123456789ABCDEF
In the datasheet it looks like the ID register is only two bytes.  Not sure
what you mean here.  I don't think it really matters what goes there though
if you aren't using it in your app.

Nick

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads