Thanks, I'll look into this. In the meantime, any idea on what a typical cost per small (say 4" x 3" x 3" or so) box in a quantity of 10 or so? Nick ----- Original Message ----- From: "Alexander JJ Rice" To: Sent: Sunday, February 08, 2004 8:28 PM Subject: Re: [PICLIST] [OT:] Decals > On Sun, 8 Feb 2004 15:30:09 -0600, James Nick Sears > wrote: > > > I learned of frontpanelexpress in a thread here a while back and it looks > > like a great service that I would like to try (same for emachinesop, > > which > > was discussed in the same thread) but this project has to be watertight > > so I > > can't really use a front panel, per se. > > > > But could I send my aluminum enclosures to them (or even just the lids) > > to > > have lettering, logos, etc. milled and anodized? I looked at their > > website > > and it shows a pic from a screenshot of their application that shows a > > "Use > > customer's material" checkbox, but I can't find details on the website on > > the limitations of the supplied material. > > > > Thanks, > > Nick > > You ought to investigate laser engravers in your area - have the whole > thing anodised and then have the lettering or whatever laser engraved into > it. it gives a much nicer effect than milling and is probably cheaper too. > > Regards > > Alex > > -- > http://www.piclist.com hint: The PICList is archived three different > ways. See http://www.piclist.com/#archives for details. > -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body