>>Ken Pergola wrote:
>> 4) Signal line ringing issues due to improper line termination?
>> Perhaps 270 ohm series resistors instead of 2000 ohm resistors?

>From: Olin Lathrop [mailto:olin_piclist@EMBEDINC.COM]
>I don't want to go much below 2Kohm for other reasons, but
>you're getting close.

Crosstalk between PGC and PGD?  Those breadboards have a lot of capacitance
between adjacent rows.

Regards

Mike




=======================================================================
This e-mail is intended for the person it is addressed to only. The
information contained in it may be confidential and/or protected by
law. If you are not the intended recipient of this message, you must
not make any use of this information, or copy or show it to any
person. Please contact us immediately to tell us that you have
received this e-mail, and return the original to us. Any use,
forwarding, printing or copying of this message is strictly prohibited.
No part of this message can be considered a request for goods or
services.
=======================================================================
Any questions about Bookham's E-Mail service should be directed to
postmaster@bookham.com.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body