> > 4) Signal line ringing issues due to improper line termination?
> > Perhaps 270 ohm series resistors instead of 2000 ohm resistors?
>
> I don't want to go much below 2Kohm for other reasons, but
> you're getting
> close.

I recall that earlier versions of Wisp628 used 470 ohm series sesistors,
I now use 47 ohm.

But Olin, did you realy say you are using the programmer-PIC and the
programmed-PIC at different Vcc's with only a series resistor to prevent
touble? Naughty naughty you!

Wouter van Ooijen

-- -------------------------------------------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body